Jog/Shuttle Direction Indicators; Shuttle/Jog Dial; Standby Indicator; Shtl/Jog Button - Sony XDS-PD1000 Operation Manual

In VTR mode, you can monitor the input signal in E-E
mode by pressing this button when in stop condition. To
return to the original image, press the STOP button.
Pressing this button during playback or searching will
output an E-E mode image for the duration while the
button is pressed.
f REC INHI (recording inhibit) indicator
Lights when a Professional Disc or SxS memory card is
selected as the operation target media and the media is
loaded in record-inhibited state (see page 52 and page 54).
g STANDBY indicator
Lights when the unit is put into media stop mode. After a
certain time passes in a media stop mode, the unit
automatically enters standby off mode and the indicator
goes off.
You can specify the time until the unit enters standby off
mode.
For details, see the description of setup menu item 501
STILL TIMER (see page 115).
7 Shuttle/jog/variable-speed playback
control section

1 SHTL/JOG button

2 VAR/JOG button

3 JOG indicator

a SHTL/JOG button
Press this button, turning it on, to perform shuttle or jog
playback with the shuttle/jog dial.
b VAR/JOG button
Press this button, turning it on, to perform variable-speed
or jog playback with the shuttle/jog dial.
c JOG indicator
Lights in green when the shuttle/jog dial is in jog mode.
4 Jog/shuttle direction
indicators

5 Shuttle/jog dial

d Jog/shuttle direction indicators
These show the playback direction in jog, shuttle, or
variable-speed mode.
b (green): Lights during playback in the reverse direction.
B (green): Lights during playback in the forward
direction.
x (red): Lights during still image display.
e Shuttle/jog dial
The dial switches between shuttle/variable-speed mode
and jog mode each time that you press it all the way in.
Shuttle/variable-speed mode: The dial is in the raised
position.
Jog mode: The dial is in the depressed position (the JOG
indicator is lit).
Turn the dial to the right to play in the forward direction,
and turn it to the left to play in the reverse direction.
• In jog mode, the playback speed varies from –1 to +1
times normal speed, according to the rotation speed of
the dial. There are no detents.
• In shuttle mode, the playback speed varies in the range
±20 times normal speed, according to the angular
position of the dial. There is a detent at the center
position, for still image playback.
• In variable-speed mode, you can make fine adjustments
to the playback speed over the range from –2 to +2 times
normal speed, according to the angular position of the
dial. There is a detent at the center position, for still
image playback.
Regardless of the playback mode, you will normally press
the SHTL/JOG or VAR/JOG button before turning the
dial. But it is also possible to put the unit into shuttle, jog,
or variable-speed mode simply by turning the dial (by
setting setup menu item 101 SELECTION FOR SEARCH
DIAL ENABLE to "dial").
Note
If you do set the above item to "dial", then you should
return the shuttle/jog dial to the center position after
conducting shuttle or variable-speed playback. If you do
not return the dial to the center position, playback in
shuttle or variable-speed mode can start because of
vibrations during other operations.
23
Front Panel