Sony XDS-PD1000 Operation Manual page 124

Item number Item name
926 14 PID(AUX2)
930 DOWN CONVERTER MODE
931 DOWN CONVERTER LETTER BOX
MODE
932 H CROP POSITION (DC)
934 CROSS COLOR (DC)
935 DETAIL GAIN (DC)
936 LIMITER (DC)
937 CRISP (DC)
938 LEVEL DEPEND THRESHOLD
a)
(DC)
939 H DETAIL FREQUENCY (DC)
940 H/V RATIO (DC)
942 V FILTER SELECT (DC)
943 CROSS COLOR CRISP (DC)
944 D/C LEGALIZE (DC)
950 UP CONVERTER MODE
124
Setup Menu
Menu items in the 900s, relating to digital process
a)
a)
a)
a)
a)
a)
a)
a)
a)
a) c)
a)
a)
Settings
Changes the AUX2 packet PID value for DVB-ASI output.
30 to 811 to 1FFE: Set PID value (as a hexadecimal value).
You can set the value over the range from 30 to 1FFE in 1 units (or
200 units, when the SHIFT button is held down).
- - -: When sub item TS MODE of menu item 926 is set to "HDV".
Note
Do not set to the same PID value as other values.
Select the down-converter mode.
EDGE CROP [CROP]: Select the edge crop mode.
LETTER BOX [L-BOX]: Select the letter box mode.
SQUEEZE [SQUEZ]: Select the squeeze mode.
Select the aspect ratio of the down-converter output when menu item
930 is set to "LETTER BOX".
16:9: Set the aspect ratio of the HD-SD converter output to 16:9.
14:9: Set the aspect ratio of the HD-SD converter output to 14:9.
13:9: Set the aspect ratio of the HD-SD converter output to 13:9.
Adjust the H-crop (the horizontal position when cropping in the edge crop
mode) of the down-converter output when menu item 930 is set to
"EDGE CROP".
–120 to 0 to 120
Adjust the down-converter cross color.
0 to 8 to 15
Adjust the down-converter image enhancer. Adjust the sharpness of
edge enhancement.
0 to 7F (HEX)
Adjust the down-converter image enhancer. Set the maximum detail level
added to emphasize the original signal.
0 to 20 (HEX) to 3F (HEX)
Adjust the down-converter image enhancer. Set the threshold amplitude
for emphasis (signals of amplitude lower than the threshold are not
emphasized).
0 to F (HEX)
Adjust the down-converter image enhancer. Set the luminance range for
edge enhancement.
0 to 8 to F (HEX)
Adjust the down-converter image enhancer. Set the central frequency for
edge enhancement.
2.6MHz, 3.4MHz, 3.9MHz, 4.6MHz
Adjust the down-converter image enhancer. Set the horizontal/vertical
ratio for edge enhancement.
0 to 3 to 7
Set the vertical interpolation filter coefficient for down-converter output (in
1080 mode only).
If the setting value is large, the vertical resolution is high.
1 to 3
Set the cross color crisp level for down-converter output.
0 to 4 to F (HEX)
For down converter output, selects whether to suppress signals with
levels that are lower than the pedestal level.
off: Do not suppress signals lower than the pedestal level.
on: Suppress signals lower than the pedestal level.
Select the up-converter mode.
EDGE CROP [CROP]: Select the edge crop mode.
LETTER BOX [L-BOX]: Select the letter box mode.
SQUEEZE [SQUEZ]: Select the squeeze mode.