Sony XDS-PD1000 Operation Manual page 144

Alarm message in clip
list screen
Copy Running!
Operation Failed!
Not Supported Format.
Copy Aborted.
Some Clip(s) are Locked.
Clip Error.
The Disc Protect TAB is
Set to Save.
Irregular Disc is in Use.
Use Professional Disc.
Set Appropriate IN/OUT
Points.
No Clip!
Cannot Expand Clip any
Further.
Clip is not Ready to Copy.
Delete is Prohibited.
This Clip is in Use.
Delete is Prohibited.
Referring EDL is in Use.
Delete is Prohibited.
Lock/Unlock is Prohibited.
This Clip is in Use.
Lock/Unlock is Prohibited.
Set Clip Flag was not
Performed.
One Clip is being
Recorded.
Use Single Selection.
Operation is not
Supported for EDL.
Operation is not
Supported for this Folder.
Adding EM was not
Performed.
Over DUR!
Copy to /Clip is not
Permitted.
Change Dest to
/UserData.
Dest was Changed to
/UserData.
Copy to /Clip is not
Permitted.
Cannot Display Chapter of
this Clip.
Chapter was Changed.
Display Again.
144
Troubleshooting
Description/action
A copy operation is being performed, so another copy operation is not allowed.
The target operation failed because of generation of an internal error.
The format is not supported by this unit, so copy operation is impossible.
Copy Aborted.
The copy operation was aborted.
Some of the selected clips are locked (protected).
The clip is substandard, so the copy operation failed.
You have attempted to format a disc whose Write Inhibit tab is set so as to disable recording.
To execute formatting, set the Write Inhibit tab on the disc so as to enable recording.
The inserted disc cannot be recorded/played back on this unit.
Insert a disc that can be recorded / played back on this unit.
The settings of IN and OUT points for partial copy operation are not proper.
Check the IN and OUT point settings.
The clip selected for expansion or chapter display has been deleted. Alternatively, the Professional
Disc or memory card has been ejected.
The selected clip cannot be divided any further to display the expand thumbnails.
This alarm appears when the expand thumbnails of a clip divided into the maximum number of
blocks are displayed or when the EXPAND function button has been pressed with the expand
thumbnail screen displayed in which the duration of each block is one frame.
Chase copy cannot be performed because recording has just started.
Wait until the chase copy function is enabled.
The target clip is being used, so it cannot be deleted.
The EDL which refers to the target clip is being used, so the clip cannot be deleted.
Deletion of the target clip has failed.
The target clip is being used, so it cannot be locked/unlocked.
Lock/unlock of the target clip has failed.
Set Clip Flag function has failed.
One of the selected clips was being recorded.
To copy a clip which is being recorded, make a single selection of the clip.
You cannot select EDL to delete an essence mark or set a shot mark.
You cannot delete or lock/unlock any clip in the DISC >UserData >BPAV folder.
Essence mark setting has failed.
A clip with a duration that exceeds six hours cannot be copied.
The selected clip cannot be copied to the DISC > Clip folder.
Change the copy destination to the DISC > UserData folder.
The selected clip was not permitted for copying to the DISC >Clip folder, so it was copied to the
DISC >UserData folder.
The selected clip has failed in chapter thumbnail display.
Stop recording of a clip if any in progress.
The chapter setting information has been updated.
Try again the chapter thumbnail display.