Disconnecting Remote Connection To Media - Sony XDS-PD1000 Operation Manual

6
To execute repairs, select "OK" and press the PUSH
SET knob.
The repairs begin, and an "Update/Restore
Executing..." message appears.
The repair process cannot be interrupted.
When repairs are completed, an "Update/Restore was
successful." Message appears.
To repair additional SxS memory cards
Eject the repaired SxS memory card from the memory
card slot, and insert another SxS memory card. When
the confirmation dialog prompting whether or not to
execute repairs appears, repeat step 6.
7
After finishing repairs, select Exit and press the PUSH
SET knob.
Disconnecting remote connection to
media
You can perform operations on a Professional Disc or an
SxS memory card inserted in the unit using a remote
connection from an external device. While using a remote
connection, clip-related display and operation is disabled
on the unit. When you wish to perform media operations
from the unit, use the following procedure to disconnect
the remote connection and disable connection from
external devices. The termination process is carried out
simultaneously for discs and memory cards. You cannot
select media to be disconnected. Internal storage can be
operated from the unit even during remote connection.
Consequently, remote connections to internal storage are
not disconnected when performing the operation described
below.
1
Display a clip list screen on the display.
2
Display the Clip F menu.
3
Switch to the P2 OTHER page using the PAGE/
HOME button, and press the NET ENA (F6) button.
When remote connection is permitted, "ALL" is
displayed under the NET ENA menu on the P2
OTHER page. When disconnected, "INTERNAL" is
displayed.
A prompt appears asking for confirmation to
disconnect from the network.
4
Select "OK" and press the PUSH SET knob to
disconnect from the network.
The disconnection process begins and an
"Executing..." message appears.
When disconnection is completed, the
appears in the status display area of the display screen.
Tip
You can also press and hold the SHIFT button and press
the REMOTE button keyboard shortcut to perform the
same operation as steps 1 to 3.
To permit remote connection
After remote connection is disconnected, perform the
procedure above again to permit reconnection from an
external device.
icon
91
Media Operations