Sony XDS-PD1000 Operation Manual page 113

Item number Item name
151 GUI OPERATION
155 STREAM CHASE
156 MONITOR OUT SELECT
157 LOW REMAINING CAPACITY
ALARM
158 PLAYBACK MODE FOR INTERNAL Set whether to play multiple clips when playing clips in internal storage.
159 PROXY GENERATOR
160 INTER-MEDIA OVERLAP SELECT
a) When maintenance menu item M 397 PORT CONFIGURATION is set to "VTR mode".
b) When maintenance menu item M397 PORT CONFIGURATION is set to "1-in / 1-out mode".
Menu items in the 100s, relating to the control panels
Settings
Sets whether to disable switching to the clip list screens.
enable [ena]: Enabled
via stop [stop]: Disabled (executable from stop mode only)
This setting is enabled when the target media is DISC or MEMORY.
Specify whether perform chase output with FTP/CIFS during recording.
disable (disc style) [disc]: Do not perform chase output with FTP/CIFS
(perform output in the MXF format compatible with previous devices
supporting Professional Discs).
disable (memory style) [mem]: Do not perform chase output with FTP/
CIFS (perform output in the MXF format compatible with previous
devices supporting SxS memory cards).
enable (growing style) [ena]: Perform chase output with FTP/CIFS
(perform output in the MXF format unique for chase output).
This unit supports MXF V1.3 format.
MXF V1.3 format supports chase output by enabling data in the header
metadata area storing information on clip length, etc. to the footer
partition at the end of the MXF file as well as to the header partition. This
enables clips being recorded to be output via FTP/CIFS and handled on
the network.
Note
When using a nonlinear editor that is not a Sony product, please contact
the maker to confirm whether it is possible or not to receive clips output
by the chase output function using MXF V1.3 format.
b)
HD-SDI MONITOR/OUTPUT2, SD-SDI MONITOR/OUTPUT2,
COMPOSITE OUTPUT MONI/2, and HDMI OUTPUT connectors:
Select the signal that is output to the LCD display.
current port [auto]: Outputs signal from the selected port.
REC port [EE]: Always outputs EE signal.
Set the internal storage recording capacity for which to display the low
remaining capacity alarm.
5%: Displays alarm when remaining recording capacity falls below 5%.
10%: Displays alarm when remaining recording capacity falls below 10%.
15%: Displays alarm when remaining recording capacity falls below 15%.
Notes
• Deleting clips so that the remaining capacity is higher than the set
value will cancel the alarm.
• 5%, 10%, and 15% are equivalent to about 24 minutes, 48 minutes, and
72 minutes, respectively, when calculated for XAVC AI422 recording.
clip: Plays single clips (clip mode).
continuous [cont]: Plays multiple clips consecutively (continuous
playback mode).
Note
When maintenance menu item M397 PORT CONFIGURATION is set to
"VTR mode", the playback mode is set to "continuous" and this item is not
displayed.
Set whether to generate proxy audio/video data when copying clips
without proxy AV data or partial clips to internal storage, the Clip folder
on Professional Discs, or UDF-format SxS memory cards, or when
uploading (PUT) from a computer using an FTP connection.
disable [dis]: Do not generate proxy AV data.
enable [ena]: Generate proxy AV data.
Set the overlap duration between media when simultaneously recording
or copying to multiple media discs/memory cards.
off: No overlap.
30 sec [30 s]: 30 seconds overlap.
1 min [1 m]: 1 minute overlap.
113
Setup Menu