Sony XDS-PD1000 Operation Manual page 130

Item
M39: OTHER M39A: XAVC to DISC
CONFIG
M3A: GPIO SETUP
Sub-item
1 IN 1
2 IN 2
3 IN 3
4 IN 4
5 OUT 1
6 OUT 2
7 OUT 3
8 OUT 4
130
Maintenance Menu
M3: OTHERS: Other setting items
Setting
Set whether XAVC data is recorded to Professional Disc and whether data is
simultaneously recorded or copied to the Clip folder on a Professional Disc.
disable [dis]: Disable XAVC recording to the Clip folder on a Professional Disc.
In XAVC simultaneous recording, data is recorded to the UserData folder on
a Professional Disc.
enable [ena]: Enable XAVC recording to Professional Disc. In XAVC
simultaneous recording, data is recorded to the Clip folder on a Professional
Disc.
Note
When recording to Professional Disc for use on another XDCAM device, set this
item to disable to record XAVC data to the UserData folder.
Set commands and statuses to be assigned to the pins of the GPIO connector.
off: Do not assign any command or status.
Commands to be assigned to pins IN 1 to IN 4:
PB-STOP COMMAND [P.STP]: STOP command to the playback port
PB-PLAY COMMAND [PLAY]: PLAY command to the playback port
PB-RECUE COMMAND [RECUE]: RECUE command to the playback port
REC-STOP COMMAND [R.STP]: STOP command to the recording port
REC-REC COMMAND [REC]: REC command to the recording port
Statuses to be assigned to pins OUT 1 to OUT 4:
ALARM STATUS [ALARM]: Status of the alarm (ON when an error occurs)
ALARM2 STATUS [ALARM2]: Status of the alarm 2 (ON when an error or
warning occurs)
PB-STOP STATUS [P.STP]: Stop status of the playback port
PB-PLAY STATUS [PLAY]: Playback status of the playback port
REC-REC STATUS [REC]: Recording status of the recording port
Set the command to be assigned to pin IN 1.
PB-STOP COMMAND [P.STP]
Set the command to be assigned to pin IN 2.
PB-PLAY COMMAND [PLAY]
Set the command to be assigned to pin IN 3.
PB-RECUE COMMAND [RECUE]
Set the command to be assigned to pin IN 4.
off
Set the status to be assigned to pin OUT 1.
PB-PLAY STATUS [PLAY]
Set the status to be assigned to pin OUT 2.
off
Set the status to be assigned to pin OUT 3.
off
Set the status to be assigned to pin OUT 4.
ALARM STATUS [ALARM]