Sony XDS-PD1000 Operation Manual page 129

Item
M37: AUDIO M370: HEAD ROOM
CONFIG
M371: DATA LEN
M372: NON-AUDIO
INPUT
Sub-item
1 Tr1/Tr2
2 Tr3/Tr4
3 Tr5/Tr6
4 Tr7/Tr8
M373: IN LEVEL
Sub-item
1 CH1/3/5/7
2 CH2/4/6/8
M377: OUT LEVEL
M39: OTHER M391: VITC REC
CONFIG
M395: FRMT MEDIA
M397: PORT
CONFIGURATION
M398: VDCP STATUS
MODE
M3: OTHERS: Other setting items
Setting
Select the audio reference level (headroom).
–20dB, –18dB, –16dB, –12dB, EBUL
Note
EBUL can be selected only when the system frequency is 50i/25P.
Select the audio channel configuration for IMX recording.
16bit x 8ch [16x8]: 16-bit, 8-channel configuration
24bit x 4ch [24x4]: 24-bit, 4-channel configuration
Select whether to handle digital audio signals as non-audio signals during
recording.
audio: Handle as linear PCM audio signals.
data: Handle as non-audio signals.
Set the upper limit for the signal level input to audio channels 1/3/5/7 or 2/4/6/8.
+4dB, 0dB, –3dB, –6dB, EBUL
Note
EBUL can be selected only when the system frequency is 50i/25P.
Set the reference level for audio output signals.
+4dB, 0dB, –3dB, –6dB, EBUL
Note
EBUL can be selected only when the system frequency is 50i/25P.
Select whether to record the VITC in the input HDSDI signals in the LTC user bits
area.
disable [dis]: Do not record.
enable [ena]: Record.
Notes
• Recording of VITC is enabled only when this is set to "enable," and F1:TCG is
set to "EXT" and F2:PRST/RGN is set to "TC" on the P4 TC page in the function
menu.
• When set to "enable," the value in the user bits area is output for VITC during
playback. Note that the value of the user bits area is output for VITC even when
playing back clips recorded without using this function.
• This setting has no affect during SD format recording/playback.
Specify whether to disable the Format Media command of the Clip Menu.
disable [dis]: Disable the Format Media command.
enable [ena]: Enable the Format Media command.
Set the port operation mode.
1-in/1-out mode [i/o]: Ports operate independently.
VTR mode [vtr]: Ports operate together as input and output connectors.
Set the operations to reflect in the VDCP status.
VDCP [vdc]: Only operations via VDCP are reflected in the VDCP status.
VDCP/FP/NetRMT [all]: Operations from VDCP, remote connection, and the
front panel are reflected in the VDCP status.
129
Maintenance Menu