Changing The Front Turn Indicator Bulb - Malaguti Password 250 i.e. Workshop Manual

PASSWORD 250 i.e.

CHANGING THE FRONT TURN INDICATOR BULB

• Undo screw (V) (right or left, depending on which bulb
you need to replace) responsible for securing the
handlebar casings;
• use both hands to separate the two casings;
• remove the rubber bulbholder by turning it counter-
clockwise;
• change the bulb;
• refit the rubber bulbholder by turning it clockwise.
Secure the handlebar casing.
The rate at which the turn indicator warning
light on the instrument panel flashes will
increase to signal that one of the four
indicators is not working.
When performing the operations described
above take care not to damage parts in the
vicinity (transmissions, wiring, seals, etc.).
TAILLIGHT (with brake light)
• Parking light (A)
12V - 5W bulb (W5W)
• Brake light (B)
12V - 10W bulb (R10W)
• Rear turn indicator (C)
12V - 10W bulb (R10W)
Visually check that the taillights are working, including the
brake light, by pulling one of the brake levers.
FRAME AND RUNNING GEAR
M A I N T E N A N C E
V
C
A
43 11/06
A
4
C
B A