Introduction - Yealink SIP-T2xP Auto Provisioning Manual

Yealink IP phones are full-featured telephones that can be plugged directly into an IP
network and can be used easily without manual configuration.
This guide provides instructions on how to provision Yealink IP phones with the minimum
settings required. Yealink IP phones support FTP , TFTP , HTTP , and HTTPS protocols for auto
provisioning and are configured by default to use the TFTP protocol.
The purpose of this guide is to serve as a basic guidance for provisioning Yealink IP
phones, including:
Yealink SIP-T28P

Yealink SIP-T26P

Yealink SIP-T22P

Yealink SIP-T21P

Yealink SIP-T20P

Yealink SIP-T19P

Yealink SIP-T48G

Yealink SIP-T46G

Yealink SIP-T42G

Yealink SIP-T41P

Yealink CP860

The auto provisioning process outlined in this guide applies to Yealink SIP-T2X and
SIP-T4X phones running firmware V72 or later or Yealink CP860 running firmware V72 or
later. We recommend that SIP-T2X and SIP-T4X IP phones running firmware V72 or later
CANNOT be downgraded to an earlier firmware version. The new firmware is
compatible with old configuration parameters, but not vice versa.
This guide is also applicable to SIP-T21/T20/T19 IP phones.

Introduction

1