Yealink IP Phones Auto provisioning Guide
Parameter
SIP-T20P IP phones)
network.pc_port.dhcp_server =
(only applicable to SIP-T28P , SIP-T26P , SIP-T22P and
SIP-T20P IP phones)
network.dhcp.start_ip =
(only applicable to SIP-T28P , SIP-T26P , SIP-T22P and
SIP-T20P IP phones)
network.dhcp.end_ip =
(only applicable to SIP-T28P , SIP-T26P , SIP-T22P and
SIP-T20P IP phones)
network.internet_port.speed_duplex =
82
Permitted Values
Router.
The default value is 255.255.255.0.
It takes effect after a reboot.
It enables or disables the phone to act as a
DHCP server when the PC (LAN) port is
configured as Router.
0-Disabled
0 or 1
1-Enabled
The default value is 1.
It takes effect after a reboot.
It configures the start IP address of the
DHCP IP segment.
IP address
The default value is 10.0.0.10.
It takes effect after a reboot.
It configures the end IP address of the DHCP
IP segment.
IP address
The default value is 10.0.0.100.
It takes effect after a reboot.
It configures the transmission mode and
0, 1, 2, 3, 4 or 5
speed of the Internet (WAN) port.
Descriptions
Network->PC Port ->PC Port Config
->As Router ->Enable DHCP Server
Network->PC Port ->PC Port Config
->As Router->Start IP Address
Network->PC Port ->PC Port Config
->As Router->End IP Address
Network-> Advanced->Port Link->
WAN Port Link
Web Setting Path