Removing The Rear System Fan - Lenovo ThinkServer TS100 Hardware Maintenance Manual

Removing the rear system fan

Attention:
v Replace a failed fan within 48 hours.
v To ensure proper cooling and airflow, do not operate the server for more than 30
To remove the rear system fan, complete the following steps:
1. Turn off the server and all attached devices; then, disconnect all power cords
2. Unlock and remove the side cover (see "Removing the side cover" on page 62).
3. Remove any adapters that impede access to the fan and the fan connector on
4. Disconnect the fan cable from the system board, making a note of where the
5. Grasp the fan 2 with both hands and pull firmly, extending the rubber
6. Pull the fan up and out of the chassis.
7. If you are instructed to return the fan, follow all packaging instructions, and use
88
ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual
minutes with the side cover removed.
and external cables.
the system board (see "Removing an adapter" on page 68).
cable was connected, for later installation.
grommets 1 . The grommets will be pulled through the holes in either the fan
or the chassis and can then be removed.
any packaging materials for shipping that are supplied to you.