Removing The Simple-Swap Backplate - Lenovo ThinkServer TS100 Hardware Maintenance Manual

2. Route the hard disk drive signal and power cables through the slots 2 on the
3. Rotate the hard disk drive fan assembly toward the backplane until the release
4. Rotate the drive cage toward the front of the server until it stops; then, press
5. Connect the hard disk drive fan assembly cable to the system board (see
6. Reinstall the hard disk drives.
7. Install the side cover (see "Installing the side cover" on page 63).
8. Lock the side cover if you unlocked it during removal.
9. Reconnect the external cables and power cords; then, turn on the attached

Removing the simple-swap backplate

This procedure applies only to server models with the simple-swap SATA backplate
installed on the back of the hard disk drive cage.
To remove the simple-swap backplate, complete the following steps:
10. Lift up on the retaining latch 5 at the top of the drive cage; then, tilt the top
edge of the hard disk drive fan assembly 3 . Make sure that the cables will not
be pinched between the hard disk drive assembly and the hard disk drive
backplane when the assembly is installed.
tabs are fully engaged on the drive cage.
and hold the retaining tab on top of the drive cage while you rotate the drive
cage into the chassis until it locks into place.
"System board internal connectors" on page 10 for the location of the hard disk
drive fan connector).
Note: Before you continue, check all internal power cables to be sure that they
are connected to the system board and other optional devices.
devices and turn on the server.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 57.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock and remove the side cover (see "Removing the side cover" on page
62).
4. Remove the lower bezel (see "Removing the lower bezel" on page 64).
5. Remove the simple-swap hard disk drives that are installed in the hard disk
drive cage (see "Removing a simple-swap hard disk drive" on page 79).
6. Remove the hard disk drive fan assembly from the hard disk drive cage (see
"Removing the hard disk drive fan assembly" on page 90).
7. Disconnect the power cables from the simple-swap backplate.
8. Disconnect the signal cables from the system board.
9. Press and hold the drive cage release tab 2 ; then, rotate the drive cage out
of the chassis until the retaining tab 1 on top of the cage locks into place.
of the simple-swap backplate 4 away from the drive cage until it is clear of
the locating pins 3 .
Chapter 4. Removing and replacing server components
93