Connecting the cables
You must turn off the server before you connect any cables to or disconnect any
cables from the server.
Note: If the cable that you are connecting or disconnecting is a USB cable,
however, you do not have to turn off the server.
See the documentation that comes with optional devices for additional cabling
instructions. It might be easier for you to route cables before you install certain
devices.
For details about the locations and functions of the input/output connectors, see
"Server controls, LEDs, and power" on page 5.
The following illustration shows the locations of the input/output connectors.
Detailed cabling instructions for installing the server in a rack are in the Rack
Installation Instructions that come with the server.
1
Ethernet transmit/ receive activity LED
(amber)
2
Ethernet link status LED (green)
3
Remote Supervisor Adapter II
SlimLine (Ethernet) connector
4
USB connectors 1 and 2
5
Ethernet connector
6
USB connectors 3 and 4
7
Video connector
8
Serial 1 (Com1) connector
9
Parallel connector
10
Serial 2 (Com2) connector
11
DC power LED
12
AC power LED
13
Power cord connector
Chapter 4. Removing and replacing server components
61