Server Power Features - Lenovo ThinkServer TS100 Hardware Maintenance Manual

Video connector
USB connectors
Ethernet connector
Ethernet transmit/receive activity LED
Ethernet link status LED
Remote Supervisor Adapter II SlimLine/Ethernet connector

Server power features

When the server is connected to an ac power source but is not turned on, the
operating system does not run, and all core logic except the service processor is
shut down; however, the server can respond to requests from the service processor,
such as a remote request to turn on the server. The power-on LED flashes to
indicate that the server is connected to ac power but not turned on.
Turning on the server
Approximately 20 seconds after the server is connected to ac power, the
power-control button becomes active, and one or more fans might start running to
provide cooling while the server is connected to power. You can turn on the server
and start the operating system by pressing the power-control button.
The server can also be turned on in any of the following ways:
v If a power failure occurs while the server is turned on, the server will restart
v If your operating system supports the systems-management software for an
v If your operating system supports the Wake on LAN feature, the Wake on LAN
v If an optional Remote Supervisor Adapter II SlimLine is installed in the server, the
Note: When 4 GB or more of memory (physical or logical) is installed, some
memory is reserved for various system resources and is unavailable to the
operating system. The amount of memory that is reserved for system resources
depends on the operating system, the configuration of the server, and the
configured PCI optional devices.
Turning off the server
When you turn off the server and leave it connected to ac power, the server can
respond to requests from the service processor, such as a remote request to turn
8
ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual
Connect a monitor to this connector.
Connect USB devices to these connectors.
Use this connector to connect the server to a network.
This LED is on the Ethernet connector on the rear of the server. When this
LED is lit, it indicates that there is activity between the server and the
network.
This LED is on the Ethernet connector on the rear of the server. When this
LED is lit, it indicates that there is an active connection on the Ethernet
port.
Use this connector to connect the Remote Supervisor Adapter II SlimLine to
a network.
automatically when power is restored.
optional Remote Supervisor Adapter II SlimLine, the systems-management
software can turn on the server.
feature can turn on the server.
server can be turned on from the Remote Supervisor Adapter II SlimLine user
interface.