Removing And Replacing Optional-Service Crus; Removing The Battery; Installing The Battery - Lenovo ThinkServer TS100 Hardware Maintenance Manual

Removing and replacing optional-service CRUs

You may install an optional-service CRU yourself or request Lenovo to install it, at
no additional charge, under the type of warranty service that is designated for the
server.
The illustrations in this document might differ slightly from your hardware.

Removing the battery

To remove the battery, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Unlock and remove the side cover (see "Removing the side cover" on page 62).
4. Remove any adapters that impede access to the battery.
5. Locate the battery on the system board (see "System board internal connectors"
6. Remove the battery:

Installing the battery

The following notes describe information that you must consider when you replace
the battery in the server.
v You must replace the battery with a lithium battery of the same type from the
v To order replacement batteries in U.S. and Canada, call Lenovo Service and
v After you replace the battery, you must reconfigure the server and reset the
v To avoid possible danger, read and follow the following safety statement.
86
ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual
on page 57.
and external cables.
on page 10).
a. Use a fingernail to press the top of the battery clip away from the battery.
The battery pops up when it is released.
b. Use your thumb and index finger to lift the battery from the socket.
same manufacturer.
Support. Outside the U.S. and Canada, call your Lenovo marketing
representative or authorized reseller.
system date and time.