Removing The System Board - Lenovo ThinkServer TS100 Hardware Maintenance Manual

Removing the system board

To remove the system board, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 57.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Turn the server on its side so that it is lying flat, with the cover facing up.
4. Unlock and remove the side cover (see "Removing the side cover" on page
62).
5. Note where each cable is connected; then, disconnect all cables from the
system board.
6. Press and hold the drive cage release tab; then, rotate the drive cage out of
the chassis until the retaining tab on top of the cage locks into place.
7. Remove any of the following components (in addition to others that might not
be listed) that are installed on the system board and put them in a safe,
static-protective place:
v Adapters (see "Removing an adapter" on page 68).
v Microprocessor and fan sink (see "Removing the microprocessor and fan
sink" on page 118).
v DIMMs (see "Removing a memory module" on page 84).
v Battery (see "Removing the battery" on page 86).
v SAS/SATA controller (see "Removing the mini-SAS/SATA controller" on page
106 ).
8. Remove the two screws that secure the Remote Supervisor Adapter II
SlimLine adapter-support bracket 1 to the system board and remove the
Remote Supervisor Adapter II SlimLine adapter-support bracket from the
system board. Set it aside for use later.
9. Remove the eight screws that secure the system board to the chassis.
Chapter 4. Removing and replacing server components
123