Installing A Non-Hot-Swap Power Supply - Lenovo ThinkServer TS100 Hardware Maintenance Manual

Types 6431, 6432, 6433, and 6434
Hide thumbs Also See for ThinkServer TS100:
Table of Contents

Advertisement

Installing a non-hot-swap power supply

This procedure applies only to server models that have a non-hot-swap power
supply. See "Installing a hot-swap power supply" on page 83 for information about
the installation of a hot-swap power supply.
To install a non-hot-swap power supply, complete the following steps:
1. Position the power supply in the chassis so that the screw holes in the power
2. Install the four screws that secure the power supply to the chassis.
3. Connect the cables from the power supply to the system board and all internal
4. Install the side cover (see "Installing the side cover" on page 63).
5. Lock the side cover if you unlocked it during removal.
6. Reconnect the external cables and power cords; then, turn on the attached
supply are aligned with the corresponding holes in the rear of the chassis.
components.
devices and turn on the server.
Chapter 4. Removing and replacing server components
117

Advertisement

Table of Contents
loading

This manual is also suitable for:

6431643264336434

Table of Contents