Lenovo ThinkServer TS100 Hardware Maintenance Manual page 235

Table 12. Diagnostic messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.
v See Chapter 3, "Parts listing, ThinkServer TS100 Machine Types 6431, 6432, 6433, and 6434," on page 37 to determine
which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained
service technician.
Message
number Component
202-802-xxx Memory
Test State
Memory Stress Test Aborted
Description Action
Memory size is
1. Turn off and restart the system.
insufficient to run
2. Make sure that all memory is enabled
the test. At least 1
by checking the Available System
GB is required.
Memory in the Resource Utilization
section of the Diagnostic event log. If
necessary, enable all memory in the
Configuration/Setup Utility program
(press F1 at system startup).
3. Make sure that the Diagnostic code is
at the latest level. For the latest level of
Diagnostic code, go to:
http://www.lenovo.com/support.
4. Make sure that the BIOS code is at the
latest level. The installed firmware level
is shown in the Diagnostic event log in
the Firmware/VPD section for this
component. For the latest level of
firmware, start firmware, go to
EasyUpdate or go to:
http://www.lenovo.com/support and
select your system to display a matrix
of available firmware.
5. Run the test again.
6. Turn off and restart the system if
necessary to recover from a hung state.
7. Run the memory diagnostics to identify
the specific failing DIMM.
8. If the problem remains, collect the data
from the Diagnostic event log and send
it to Lenovo Service. For information
about contacting Lenovo Service, see
http://www.lenovo.com/support.
217
Chapter 5. Diagnostics