Lenovo ThinkServer TS100 Hardware Maintenance Manual page 94

10. Push the drive into the bay.
11. Connect one end of the applicable signal cable into the rear of the drive and
12. Route the signal cable so that it does not block the airflow to the rear of the
13. If you have another drive to install or remove, do so now.
14. Connect the power cable to the rear of the drive. The connectors are keyed
Removing a hot-swap hard disk drive
This procedure applies only to server models that have hot-swap hard disk drives.
Attention:
than 10 minutes without either a drive or a filler panel installed in each drive bay.
To remove a hot-swap hard disk drive, complete the following steps:
76
ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual
8. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
9. Remove the drive retainer clip from the side of the drive cage of bays 1 or 2.
Slide the drive retainer clip to the right to remove it from the drive cage; then,
snap the drive retainer clip into the screw holes on the side of the drive.
1
EMC shield
2
Filler panel
Note: A tape drive can be installed in bay 1 or bay 2
make sure that the other end of this cable is connected into the applicable
connector on the system board.
drives or over the microprocessor and dual inline memory modules (DIMMs).
and can be inserted only one way.
To maintain proper system cooling, do not operate the server for more
3
Tape drive
3
Drive retainer clip