Power pod removal and replacement
Complete the following steps to remove a power pod:
1. Review the "Safety information" on page 95 and "Installation guidelines" on
2. Turn off the server and all attached devices (see, "Turning off the server" on
3. Disconnect all external cables and power cords.
4. Remove the cover (see "Cover removal and replacement" on page 49).
5. Remove the fan assembly and air baffle (see "Fan assembly and air baffle
6. Disconnect the Y-cable from the power pod that you want to remove by
7. Loosen the four captive screws on the power pod; then, slide the power pod
8. Lift the power pod out of the server.
To replace a power pod, reverse the previous steps.
page 43.
page 9).
removal and replacement" on page 56).
releasing the connector.
away from the microprocessor to disengage the power pod from its connector.
Air baffle
180°
Chapter 5. Service replaceable units
75