Table of Contents
Advertisement
Password
From the System Security choice, you can set, change, and delete an
administrator password. The choice is on the full Configuration/Setup Utility menu
only.
An administrator password is intended to be used by a system administrator; it
limits access to the full Configuration/Setup Utility menu. If you set an administrator
password, you do not have to type a password to complete the system startup, but
you must type the administrator password to access the full Configuration/Setup
Utility menu. The administrator password can use any combination of up to seven
characters (A–Z, a–z, and 0–9) for the password.
If you set an administrative password and then forget it, do the following:
1. Turn off the server, disconnect the power cord; then, remove the cover. See
2. Move the password jumper to the alternate position. To locate the password
3. Replace the cover, see "Cover removal and replacement" on page 49; then,
Using the LSI Logic Configuration Utility program
LSI Logic Configuration is a built-in, menu-driven configuration utility program that
you can use to:
v Perform a low-level format of a SCSI hard disk drive
v Set a SCSI device scan order
v View or change SCSI IDs for attached devices
v Set SCSI protocol parameters on SCSI hard disk drives
The integrated SCSI controller with RAID capabilities supports redundant array of
independent disks (RAID). You can use the LSI Logic Configuration Utility program
to configure RAID level 1 for a single pair of attached devices. If you install a
different type of RAID adapter, follow the configuration instructions in the
documentation that comes with the adapter to view or change SCSI settings for
attached devices.
The following sections provide instructions for starting the LSI Logic Configuration
Utility program and performing selected functions.
Starting the LSI Logic Configuration Utility program
Complete the following steps to start the LSI Logic Configuration Utility program:
1. Turn on the server.
2. When a list of boot options appears, use the arrow keys to select the EFI shell;
3. From the Shell prompt, type devices -b; then, press Enter.
18
IBM eServer xSeries x382 Type 8834: Hardware Maintenance Manual and Troubleshooting Guide
"Cover removal and replacement" on page 49.
jumper on the system board, see "System board jumpers" on page 73.
connect the power cord and turn on the server.
then, press Enter.
A list of devices is displayed, as in the following example:
C T
D
T Y C I
R P F A
L E G G #P #D #C Device Name
== = = = == == == =============================================================
3E D X - 1 1 - LSI Logic Ultra320 SCSI Controller
3F D X - 1 1 - LSI Logic Ultra320 SCSI Controller
Advertisement
Table of Contents
