Power Supply Bay Removal And Replacement - IBM eServer xSeries x382 Hardware Maintenance Manual And Troubleshooting Manual

Power supply bay removal and replacement

Complete the following steps to remove the power supply bay:
10. Remove the fan assembly and air baffle (see "Fan assembly and air baffle
11. Loosen the two screws (located near memory slot 1 and the ac power
12. Loosen the two screws on top of the power supply bay.
13. Lift up the power supply bay and remove it from the server.
68
IBM eServer xSeries x382 Type 8834: Hardware Maintenance Manual and Troubleshooting Guide
1. "Safety information" on page 95 and "Installation guidelines" on page 43.
2. Turn off the server and all attached devices (see "Turning off the server" on
page 9).
3. Disconnect all external cables and power cords.
4. Remove the cover (see "Cover removal and replacement" on page 49).
5. Remove the hot-swap power supplies (see "Power pod removal and
replacement" on page 75).
6. Remove the screw securing the cable management plate from the center of
the fan assembly.
7. Disconnect the P1 cable from the front panel board, the SCSI backplane F2
cable and power cable from the SCSI backplane board and move them out of
the way.
8. Loosen the retaining screw on the peripheral bay.
9. Slide the peripheral bay toward the front of the server, lift up and remove it
from the server.
removal and replacement" on page 56).
connector) at the back of the chassis that secures the Electronics bay. Slide
the Electronics bay toward the rear of the server (approximately 1-inch) to
access and loosen the three retention screws at the rear of the power supply
bay.
Screws
Power supply bay