Table of Contents
Advertisement
5. If you have a power supply to install or remove, do so now; otherwise go to
SCSI IDs for hot-swap hard disk drives
The hot-swap-drive backplane controls the SCSI IDs for the internal hot-swap drive
bays. Table 12 lists the SCSI IDs for the hard disk drives that are connected to the
primary SCSI channel.
Completing the installation
To complete your installation, you must install the bezel; then, connect all the cables
and, for certain options, run the Configuration/Setup Utility program. Follow the
instructions in this section.
Replacing the bezel
The following illustration shows how to install the bezel on the server.
Complete the following steps to replace the bezel:
1. Insert the two tabs on the ends of the bezel into the matching holes on the
2. Push the bezel toward the server until the two tabs snap into place.
"Completing the installation".
Table 12. SCSI IDs for hot-swap hard disk drives
Device
Drive bay 1
Drive bay 2
server chassis.
SCSI ID
0
1
Chapter 4. Customer replaceable units
47
Advertisement
Table of Contents
