Cd-Rom Drive Removal And Replacement - IBM eServer xSeries x382 Hardware Maintenance Manual And Troubleshooting Manual

CD-ROM drive removal and replacement

Complete the following steps to remove the CD-ROM drive.
10. Lift the CD-ROM drive out of the tray by lifting up on the angled side of the
To replace the CD-ROM drive, reverse the previous steps.
1. Review the "Safety information" on page 95 and "Installation guidelines" on
page 43.
2. Turn off the server and all attached devices see "Turning off the server" on
page 9.
3. Disconnect all external cables and power cords.
4. Remove the cover (see "Cover removal and replacement" on page 49).
5. Remove the PCI riser assembly (see "PCI riser assembly removal and
replacement" on page 57).
6. Remove the fan assembly and air baffle (see "Fan assembly and air baffle
removal and replacement" on page 56).
7. Remove the front panel board (see "Front panel board removal and
replacement" on page 65).
8. Disconnect the cables from the rear of the CD-ROM drive and move them
aside.
9. Loosen the thumb screw holding the CD-ROM tray in place; then, slide the
CD-ROM assembly toward the rear of the server and lift the assembly out of
the server.
CD-ROM drive
drive.
CD-ROM tray
Thumb screw
Chapter 5. Service replaceable units
51