Hot-swap fan removal and replacement
Complete the following steps to remove a hot-swap fan:
52
IBM eServer xSeries x382 Type 8834: Hardware Maintenance Manual and Troubleshooting Guide
1. Review the "Safety information" on page 95 and "Installation guidelines" on
page 43.
2. Turn off the server and all attached devices (see "Turning off the server" on
page 9.
3. Disconnect all external cables and power cords.
4. If the server is rack-mounted, slide the server out far enough to remove the top
cover.
CAUTION:
Ensure that the rack is anchored securely to keep it from tilting forward
when you extend the server out of the rack.
5. Remove the cover (see "Cover removal and replacement" on page 49).
Attention:
To maintain proper cooling, replace the cover within 30 minutes.
6. Determine the fan you want to replace.
Attention:
To ensure optimal airflow and cooling, replace the fan within two
minutes.
Fan LED
Fan 1
Fan 2
Fan 3
Fan 4
Fan 5
Fan 6