Features And Specifications - IBM eServer xSeries x382 Hardware Maintenance Manual And Troubleshooting Manual

Features and specifications

The following information is a summary of the features and specifications of your
server. Depending on your server model, some features might not be available, or
some specifications might not apply.
Use the Configuration/Setup Utility program to determine the type and speed of the
microprocessor that is in your server.
Table 1. Features and specifications
Microprocessor:
v Intel Itanium 2 processor
v Level-3 cache
v 400 MHz front-side bus (FSB)
v Support for two microprocessors
Memory:
v Minimum: 1 GB
v Maximum: 16 GB
v Type: PC2100, double-data-rate
(DDR)
v Connectors: eight dual inline memory
module (DIMM) connectors, four-way
interleaved
Drives standard:
v DVD/CD-RW combo: EIDE
v One or two hot-swap SCSI hard disk
drives, depending on server model
Expansion bays:
v Two open hot-swap, slim-high,
3.5-inch drive bays (one or two SCSI
drives installed, depending on server
model)
PCI expansion slots:
v Two PCI-X 100 MHz/64-bit, full-length
v One PCI-X 133 MHz/64-bit,
full-length
Cooling:
Six speed-controlled fans
Upgradeable microcode:
BIOS upgrades (when available) can
update EEPROMs on the system board
Integrated functions:
v Dual Gigabit Ethernet controller on the
system board with two RJ-45 Ethernet
ports
v One serial port (RJ-45)
v Integrated SCSI controller with one
external Ultra320 SCSI port
v Four Universal Serial Bus (USB) v1.1
ports (two on front and two on rear of
enclosure)
v ATA-100 single-channel IDE controller
v Two VGA video connectors (one on
front and one on rear of enclosure)
v USB keyboard and mouse support
Failure LEDs:
v System status/fault
v Power
v Disk drive
v Fans
Power supplies:
v Two non-redundant hot-swap 350-watt
output (115-230 V ac) for 700-watt total
output
v Some server models come with a third
350-watt hot-swap power supply that
provides 2+1 redundancy
Electrical input:
v Sine-wave input (50 or 60 Hz) required
v Input voltage and frequency ranges
automatically selected
v Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v Input kilovolt-amperes (kVA) approximately:
– Minimum: 0.15 kVA (all models)
– Maximum: 0.80 kVA with two power
supplies, 0.62 kVA with three redundant
power supplies
Heat output:
Approximate heat output is 2259 British
thermal units (Btu) per hour (662 watts) for the
maximum server configuration.
Environment:
v Air temperature (operating): 10° to 35°C
(50° to 95°F)
v Humidity (storage): 50% to 90%
non-condensing
Acoustical noise emissions:
v Sound power, idle: 7.0 bel maximum
v Sound power, operating: 7.0 bel maximum
Size:
v Height: 87 mm (3.4 in.)
v Depth: 747 mm (29.4 in.)
v Width: 449 mm (17.7 in.)
v Weight: 30 kg (65 lb) when fully configured
Chapter 1. General information
3