System Board Removal And Replacement - IBM eServer xSeries x382 Hardware Maintenance Manual And Troubleshooting Manual

System board removal and replacement

Complete the following steps to remove the system board:
10. Loosen the screw at the rear of the chassis, which secures the retention lever
70
IBM eServer xSeries x382 Type 8834: Hardware Maintenance Manual and Troubleshooting Guide
1. Review the "Safety information" on page 95 and "Installation guidelines" on
page 43.
2. Turn off the server and all attached devices, see"Turning off the server" on
page 9.
3. Disconnect all external cables and power cords.
4. Remove the cover (see "Cover removal and replacement" on page 49.
5. Remove the PCI riser assembly, see "PCI riser assembly removal and
replacement" on page 57.
6. Remove the fan assembly and air baffle, see "Fan assembly and air baffle
removal and replacement" on page 56.
7. Remove the power pods, see "Power pod removal and replacement" on
page 75.
8. Remove a microprocessor, see "Microprocessor removal and replacement" on
page 74.
9. Remove the memory DIMMs, see "Memory DIMMs removal and replacement"
on page 63.
assembly.
Interlock tabs
Captive screw