Replacing The Elevation Gyro - KVH Industries TracVision G8 Owner's Manual

TracVision G8 Owner's Manual - Guide to Technical Information
Figure 5-21
Elevation Gyro
106

5.10 Replacing the Elevation Gyro

1. Disconnect the gyro cable from the in-line
connector.
M2.5 Screws
(x 2)
Reflector
2. Remove the two M2.5 screws securing the gyro to
the LNB/feed tube assembly. Remove the old
gyro.
3. Apply a drop of Loctite threadlocker to the threads
of the screws that you removed in Step 2. Install
the new elevation gyro and secure in place with
the two screws.
4. Connect the new gyro cable to the in-line
connector that you disconnected in Step 1.
5. Calibrate the gyro as described in
Gyros" on page 105.
Gyro Cable
Connector
Gyro
LNB
"Calibrating the
54-0198