Replacing The Antenna Gyro Assembly - KVH Industries KVHTRACVISION G4 Technical Manual

5.6 Replacing the Antenna Gyro
Assembly
1. Remove the main PCB cover, as described in
"Removing the Main PCB Cover" on page 106.
2. Remove the four Phillips screws, four washers,
and the counterweight from the end of the
antenna gyro (see Figure 5-8).
Standoffs
Counterweight
3. Using a 3 ⁄ " nut driver/socket, remove the four
8
standoffs and washers securing the antenna gyro
to the reflector bracket (see Figure 5-8). Slide the
tie-wrap, which secures the antenna gyro cable, off
the bottom right standoff.
4. Remove the tie-wraps securing the gyro cable to
the RF cables.
5. Disconnect the antenna gyro Molex connector
from the main PCB (see Figure 5-3 on page 107).
Remove the old antenna gyro assembly.
54-0147
Bracket
Gasket
Gyro
Figure 5-8
Replacing the Antenna Gyro
Assembly
Maintenance
111