KVH Industries TracVision G8 Owner's Manual page 51

TracVision G8 Owner's Manual - Guide to Technical Information
Satellite Transponder Default Data
48
4. Repeat Step 3 for each of the following
transponder categories:
• vertical high
• horizontal high
OR
• right
TracVision G8 requires that the data fields for all
transponder categories be provided. If the selected
satellite does not have information for one or more of
the transponder categories, default information should
be entered in the fields as follows:
Table 2-9
Transponder Data
Frequency
Symbol Rate
FEC Code
Network ID
Polarity and Band
5. After entering all of the necessary information,
save the settings by typing
the data is for satellite User 2).
6. Type
7. If you need to configure a second user-defined
satellite, repeat this procedure starting with Step 1
to enter data for the USER2 satellite.
You have now added your user-defined satellite(s) to the
system's satellite library. The first user-defined satellite you
configured is stored as USER1. If you configured a second
satellite, it is stored as USER2.
If you want the antenna to track one or both of these user-defined
satellites, you need to install it. To install a satellite, you can use
either the MCU, as described in
on page 43, or you can use the SATINSTALL command, as
described on the following page.
Default Value
00000
27500
the same value as provided for those
transponders with data
0x0000
whichever combinations are not
already provided
@SAVE,A<cr>
ZAP<cr> to restart the antenna.
"Installing Your Selected Satellites"
• vertical low
• horizontal low
• left
(or B if
54-0198