KVH Industries TracVision G8 Owner's Manual page 31

TracVision G8 Owner's Manual - Guide to Technical Information
Location of Baseplate Connectors
Baseplate Connectors
Data/power Cable Connectors
Connecting the Data/Power Cable
Be sure to properly align the
data/power cable with the
baseplate connector before
tightening. Connecting the cable at
an angle may damage the cable's
center tines.
28
10. Position the baseplate assembly in place over the
mounting holes, with the baseplate's connectors
(shown in Figure 2-6) facing the stern. Ensure that
all mounting holes line up and make any
necessary adjustments.
Figure 2-6
Figure 2-7
11. Connect the N-type connector end of the
data/power cable (from belowdecks) to the
baseplate, as shown in Figures 2-8 and 2-9.
Figure 2-8
To MCU
Figure 2-9
Connectors
RF3 RF1
Data/Power
F-type Connector
RF2 RF4
To Antenna
N-type Connector
54-0198