TracVision G8 Owner's Manual - Guide to Technical Information
Figure 5-27
Elevation Motor Cable
Figure 5-28
Elevation Motor (Shield Removed)
110
5.13 Replacing the Elevation Motor
1. Disconnect the motor cable from the elevation
motor.
2. Remove the motor shield by pressing on the two
sides of the shield above the release tabs.
3. Remove the four #8-32 screws and washers
securing the motor to the antenna frame. Remove
the old elevation motor.
#8-32 Screws
and Washers
Elevation Motor
Elevation Motor
Motor Cable
Connector
Release Tab
(x 4)
Elevation Belt
Motor Hub
54-0198