KVH Industries TracVision G8 Owner's Manual page 74

Selecting Active Satellite
After installing the active pair of satellites, use the Select Satellite
menu to choose which of the installed satellites will be active.
Sat Name A
corresponds to the
first satellite selected
during the Install
Satellite process.
Setting the Skew Angle
The Set Skew Angle menu allows you to manually adjust the
skew angle of the antenna's LNB.
Set Skew Angle?
Enter Next
Skew: ##.#
- Enter
54-0198
Select Satellite?
Enter Next Return
Select <SAT NAME A>
Yes Next Cancel
<SAT NAME A> selected
Return
Proceed to "Updating Satellite
Frequency Data"
+
Enter the desired skew angle.
Use the -/+ keys to set each
number. Selecting ENTER will
cycle the display through each
digit, then return to "Set Skew
Angle."
Figure 3-18
Select Active Satellite
Proceed to "Setting the Skew Angle"
Select <SAT NAME B>
Yes Next cancel
<SAT NAME B> selected
European systems only:
If DiSEqC is active on your IRD,
once the antenna restarts, the
antenna starts tracking the satellite
currently selected by the IRD,
overriding the Select Satellite
command.
Figure 3-19
Set Skew Angle Menu
Using the MCU Interface
Sat Name B
corresponds to the
second satellite
selected during the
Install Satellite
process.
73