KVH Industries TracVision G8 Owner's Manual page 131

TracVision G8 Owner's Manual - Guide to Technical Information
Tracking and Conical
Scan Commands
138
Idle Mode
Function:
Command:
Argument:
Response:
Current Cable Wrap Angle
Function:
Command:
Argument:
Response:
E.4
Table E-4 Target Location
Function:
Command:
Argument:
Response:
Analog Signal Strength Report
Function:
Command:
Argument:
Response:
halts active tracking and conical scan, then enters
idle mode
HALT
none
echoes the command
sets or reports current cable wrap angle, defined as
0° (CCW limit) to 700° (CW limit); the value is
expressed as 0000-7000 with an implied decimal
WRAPANGLE,xxxx
the desired cable wrap angle setting
Wrap Angle = xxxx
Tracking and Conical
Scan Commands
reports the target location in antenna frame. Data
format is E### for elevation in degrees 000-900 and
A#### for azimuth in degrees 0000-3599 with
implied decimals
TGTLOCATION
none
Target Location =
reports signal strength from RF detector circuit in
A/D counts (000-FFF Hex)
SIGLEVEL
none
Signal Strength = xxxx
A = E###, A####
B = E###, A####
54-0198