Table of Contents
Advertisement
Antenna Status Data Screens
Figure 3-10 shows the information available through the Get
Antenna Status mode.
(If errors detected)
No errors detected
Testing OK
Test Types
Azimuth Motor
OR
Elevation Motor
Skew Motor
Test <Test Type>
Antenna Gyro
Testing Failure
Internal Sensor
Push any Button to Proceed
RF Comms
RF Signal
RF Config
Antenna Not
Responding
Antenna ver =
RF Ver =
Push any Button to Proceed
Antenna serial #
########
Push any Button to Proceed
54-0198
Get Antenna status?
Enter
Next
Return
Get system errors?
Yes
Next
Return
Get Version?
Yes
Next
Return
#.##
#.##
Get serial number?
Yes
Next
Return
Current State
Initializing
Searching
Tracking
Idle
Error
Figure 3-10
Antenna Status Data Screens
Proceed to "Control Antenna Mode"
Get Thres/sig level?
Yes
Next
Signal level =
####
Threshold =
####
Push any Button to Proceed
Get skew angle?
Yes
Next
Skew angle
##.#
Push any Button to Proceed
Get bit error rate?
Yes
Next
Bit error rate
#####
Push any Button to Proceed
Get state?
Yes
Next
State
<Current State>
Push any Button to Proceed
Using the MCU Interface
Return
Return
Return
Return
67
Advertisement
Table of Contents
Troubleshooting
