Replacing The Antenna Gyro Assembly - KVH Industries TracVision G4 Technical Manual

5.6 Replacing the Antenna Gyro
Assembly
1. Remove the main PCB cover, as described in
"Removing the Main PCB Cover" on page 106.
2. Using a 3 ⁄ " nut driver/socket, remove the four nuts
8
and washers securing the antenna gyro to the
reflector bracket (see Figure 5-8). The nut on the
bottom right also secures a cable clamp. Set the
nuts, washers, and cable clamp aside.
Gyro
3. Disconnect the antenna gyro Molex connector
from the main PCB (see Figure 5-3 on page 107).
Remove the old antenna gyro assembly.
4. Connect the new antenna gyro's Molex connector
to the main PCB.
5. Replace the antenna gyro gasket (see Figure 5-8).
54-0147
Bracket
Gasket
Figure 5-8
Replacing the Antenna Gyro
Assembly
Make sure the cable passes
through the PCB access slot to
protect the wires from the edge of
the PCB frame.
Maintenance
111