KVH Industries TracVision G8 Owner's Manual page 107

#8-32 Locking Nuts
and Washers
(x 4)
Azimuth Belt
4. Install the new azimuth motor with the belt
positioned around the outer lip of the motor hub
(see Figure 5-25). Reinstall the screws, washers,
and locking nuts that you removed in Step 3, but
do not tighten them yet.
5. Slide the motor to adjust the belt tension for a
maximum of 1 ⁄ " (3 mm) deflection with moderate
8
finger pressure between the motor hub and
antenna pulley. Tighten the screws and locking
nuts using an 11 ⁄
3 2
readjustment may be necessary if the belt tension
results in excessive vibration.
6. Reinstall the shield that you removed in Step 2.
7. Reconnect the motor cable that you removed in
Step 1.
54-0198
" nut driver/socket. Some
Azimuth Belt
Figure 5-25
Azimuth Motor and Belt
Motor Hub
Figure 5-26
Azimuth Belt
Antenna Pulley
Maintenance
109