Table of Contents
Advertisement
EonStor S12S-R/G1032 Installation and Hardware Reference Manual
Do not disassemble or modify the BBU. If disassembled, the
BBU could leak acid, overheat, emit smoke, burst and/or ignite.
Do not pierce the BBU with a sharp object, strike it with a
hammer, step on it, or throw it. These actions could damage or
deform it and internal short-circuiting can occur, possibly causing
functional defects, acid leaks, and other hazardous results.
If a BBU leaks, gives off a bad odor, generates heat, becomes
discolored or deformed, or in any way appears abnormal during
use, recharging or storage, immediately remove it from the
subsystem and stop using it. If this is discovered when you first
use the BBU, return it to Infortrend or your system vendor.
2.9.2
Installation Procedure
To install a BBU into the controller module, please follow these
steps:
Step 1.
Step 2.
Step 3.
2-14
Remove the BBU slot dummy cover from the
chassis by loosening the retention screw using a
medium-size Phillips screwdriver, and then pulling the
dummy cover away. (See Figure 2-10)
Figure 2-10: Removing the BBU Dummy Cover
Install a BBU by aligning it with the module slot, and
then gently pushing the BBU until it is fully inserted.
Secure the BBU to the subsystem by fastening the
retention screw on the BBU. (See Figure 2-11)
Optional Battery Module Installation
Advertisement
Table of Contents
