Table of Contents
Advertisement
EonStor S12S-R/G1032 Installation and Hardware Reference Manual
RAIDWatch Manager software and its manuals, Installation and
Hardware Reference Manual (this document), and the RAID
Subsystem firmware Operation Manual (Firmware).
2.5.1
Preinstalled Components
The following are pre-installed components:
2.5.2
Modules to be Installed
Hard drives are delicate and should be installed onsite:
2.6
Rackmounting
PN: IFT-9279CSlider36
The enclosure is designed to fit into a variety of 19-inch rack
cabinets or racks. Make sure you have an appropriate site
location and cables prepared with adequate lengths to connect to
main power and other devices.
One rackmount rail type is available from Infortrend for installing
the subsystem into a rack or cabinet. Please contact your system
vendor for further details.
Secure the subsystem chassis to the front rack posts using the
two (2) screw holes on the forearm handles or the chassis ears.
To install the subsystem into a rack or cabinet, please refer to the
installation instructions that came with the rackmount rails.
2-8
1 - LCD keypad panel
2 - Forearm handles
1 - Backplane board
1 - Controller module(s)
2 - PSUs
2 - Cooling modules
Hard drives (separately purchased SAS/SATA-II drives)
Drive trays
Rackmounting
Advertisement
Table of Contents
