Table of Contents
Advertisement
EonStor S12S-R/G1032 Installation and Hardware Reference Manual
3.
2.7.2
Drive Installation
Step 1.
Step 2.
2-10
Only use screws supplied within the shipping package.
Longer screws may damage the hard drives.
Place the hard drive into the drive tray. Make sure
the hard drive is oriented that the drive's interface
connector is facing the open side of the drive tray and
its label side facing up. If SAS drives are preferred, the
MUX boards on drive trays should not be used.
Figure 2-4: Installing a Hard Drive
Adjust the drive's location until the mounting holes in
the drive canister are aligned with those on the hard
drive. Secure the drive with four (4) supplied 6/32
flathead screws. See the diagram below for the screw
hole locations using a drive tray with or without a MUX
board.
Figure 2-5: Screw Hole Locations
Hard Drive Installation
Advertisement
Table of Contents
