Table of Contents
Advertisement
EonStor S12S-R/G1032 Installation and Hardware Reference Manual
Keep a replacement on hand: If a hard drive has failed, make
sure you have a replacement hard drive readily available before
removing the failed drive from the subsystem. Do not leave the
tray slot open for an extended period of time or the normalized
airflow will be disrupted and subsystem components will overheat
and may become permanently damaged.
5.7.2
Replacing a Hard Drive
To replace a hard drive, please follow these steps:
Hard drives are fragile; therefore, always handle them with
extreme care.
Step 1.
Step 2.
Step 3.
5-20
WARNING!
Do not drop a hard drive.
Always be slow, gentle, and careful when handling a hard
drive.
Handle a hard drive only by the edges of its metal cover,
and avoid touching its circuits part and interface connectors.
Identify the location of the drive tray that contains a
hard drive indicated as faulty. You may use firmware
utility or RAIDWatch software to locate a faulty drive.
The drive tray LED should also light red.
Make sure the rotary bezel lock is turned to the
unlocked position, (See Figure 5-15) i.e., the groove
on its face is in a horizontal orientation. Use a flathead
screwdriver to turn the rotary lock to the unlocked
orientation.
Figure 5-15: Drive Tray Rotary Bezel Lock
Open the front flap by pushing the release button at the
front of the drive tray. (See Figure 5-16) The front flap
will automatically swing open.
Replacing a Failed Hard Drive
Advertisement
Table of Contents
