Table of Contents
Advertisement
EonStor S12S-R/G1032 Installation and Hardware Reference Manual
1.3.2
Drive Tray
PN: IFT-9279CDTray
The S12S enclosure comes with drive trays (see Figure 1-7)
designed to accommodate separately purchased standard 1-inch
pitch, 3.5-inch SAS/SATA disk drives. The drive bays are accessible
from the front side of the chassis. Two (2) LEDs on the tray bezel
indicate operating statuses. A rotary bezel lock prevents accidental
removal, while a convenient release button ensures fast and efficient
drive swapping. There are screw holes on the sides of the drive tray
for securing hard drives to the drive tray.
Be careful not to warp, twist, or contort the drive tray in any way
(e.g., by dropping it or resting heavy objects on it). The drive tray
has been customized to fit into the drive bays in the subsystem. If
the drive bay superstructure is deformed or altered, the drive trays
may not fit properly into the drive bay.
The diagram below shows drive bays that are numbered from Slot 1
to Slot 12 (see Figure 1-8), from left to right, and then from top to
bottom. This numbering sequence is important when replacing a disk
drive. Replacing a wrong drive can fatally fail a logical RAID array.
1-6
Figure 1-7: Drive Tray Front View
WARNING!
Figure 1-8: S12S Drive Bay Numbering Sequence
Major Subsystem Components
Advertisement
Table of Contents
