Com1 Serial Port Cable - Infortrend EonStor S12S-R1032 Installation And Hardware Reference Manual

EonStor S12S-R/G1032 Installation and Hardware Reference Manual
A12
A13
C.2

COM1 Serial Port Cable

COM1 Cable: This cable connects between COM1 serial port on the
controller module to the serial port of a management computer. The
serial port's defaults and requirements are:
1. Set at 38400 baud, 8 bit, 1 stop bit, and no parity.
2. In most cases, connecting RXD, TXD, and GND is enough to
establish communications with a terminal.
PN: IFT-9270ASCab
CN1 Pin Number
CN2 Pin Number
Table C-2: COM1 Adapter Cable CN1 and CN2 Pinout
C-2
RX3- B12
GND B13
Table C-1: SAS Port Pinout Definitions
Figure C-2: Adapter Cable for COM1 - Connector Pinouts
Pin Name
1 Ground
2 TXD
3 RXD
Pin Name
1 NC
2 RXD
3 TXD
4 DTR (Shorted)
5 GND
6 DSR (Shorted)
7 RTS (Shorted)
8 CTS (Shorted)
9 NC
Definitions
TX3-
GND
COM1 Serial Port Cable