Panel Cut-Out Mounting Precaution; Ergonomics - Hatteland HD 12T04 series User Manual

General Installation Recommendations

Panel cut-out mounting precaution

If you intend to mount the bracket / stand-alone product into a
precut panel, make sure you have read and understood the following
section. The Series 2 frameless design means that the front glass
reaches all the way to the outer rims of the product.
Further, between the product chassis and the backside of the glass
there is a small gap which is fi lled with a gasket. This little gap is
subject of beeing "hooked" into the cut-out area edge if it is really
tight and you mount the product hasty. Also, if your panel cut-out
have small deviations you can accidentally break the glass edges.
Try to slide the product gently straight forward and avoid skewing the product. Do not force the
product into place. If you find yourself in this position and notice that the back of the glass edge
is forced forward by the panel cut-out edges or you suspect a pressure building up, remove the
product, carefully modify the panel cut-out and check the dimensions again. The product can not
be adjusted / modified in any way. The modifcation/adjustment has to be performed on the cut-out.
1: Start sliding the product into the cut-out area 2: Continue to slide, while checking the corners 3: Glass edge now aligned. Fasten the product.

Ergonomics

1. The product glass is covered by a clear protective plastic film. After installation & mounting is
completed, remove this film by lifting it at a corner, and slowly pealing it off the glass.
The front surface of the display glass has an anti-reflective (AR) coating which can be scratched
and damaged with improper cleaning. After removing the protective film the glass surface will
require cleaning. It is recommended to use only 90+% pure Isopropyl alcohol (Isopropanol)
and a soft fabric cloth for this first cleaning. Fold a cloth into a small pad, dampen the cloth
with alcohol, and wipe the glass from one edge to the other in one direction with one continuous
motion.
The product glass will require cleaning as needed. The soft cloth & alcohol wipe is
recommended to clean fingerprints and oils off the glass. Water stains (including coffee, tea &
coke) should be first cleaned off the glass with a soft fabric cloth wet with water, immediately
followed with wiping using an alcohol wetted cloth.
Installation
IND100078-12
17
INB100026-1 (Rev 9)