User Controls - Hatteland HD 12T04 series User Manual

User Controls

NAVIGATOR OVERVIEW - Maritime Multi Display (MMD):
The products features a multi functional user control via the navigator rotary & push knob with 8 independent LEDs
for multiple feedback on different status/modes that may occur during usage. With this navigator you can also control
brightness and navigating the OSD menu for further preferences. Two different versions are available of this navigator:
Bracket Version (i.e. cockpit use)
Console Version (i.e. flybridge use)
The navigator is mounted into the glass by factory default and can not be replaced afterwards. The console version
of the user controls in front is IP66 rated. Please refer to the illustrations below to determine what version you have
and how to operate the unit. The USB connector is located behind the HATTELAND® rubber hatch in the right lower
corner in the front. The rubber hatch IS NOT designed to be removed, but lifted/bended away as the arrow below
shows. Use a pen, nail or similar to open the hatch. The rubber hatch can later be pushed back into place when the
USB front connector is not in use.
1-BUTTON VERSION WITH FRONT USB BEHIND RUBBER HATCH:
With rubber hatch in place ->
1-BUTTON VERSION:
-BUTTON VERSION:
Power ON:
To turn the unit on, push the navigator knob/button inwards. The unit will start searching for signal sources. A green led
will move around the led ring. Please read the STATUS LED overview on the next page for verification on the various
LED patterns.
Power OFF:
To turn the unit off, push the navigator knob/button inwards and hold it down for 6 seconds, after 3 seconds the menu
will appear. 3 seconds later the unit is turned off, and all LED indicators will turn red. Also read the STATUS LED
overview on the next page for various LED patterns.
Operation
IND100064-13
= 1-button (with rotary switch and USB Connector)
= -button (without rotary switch and USB Connector)
Rotary Function
Push Function
+HOT KEY function
Decrease/Increase Push Function
Push Function
+HOT KEY function
Status LED Ring
Status LED Ring
2
INB100026-1 (Rev 9)
Rubber hatch lifted away ->