Hatteland HD 12T04 series User Manual page 33

On Screen Display (OSD) Menu Functions
1 LOAD DEFAULT: (Click to enter sub-menu)
2
4
3
LOAD USER DEFAULT
SAVE USER DEFAULT
LOAD FACTORY DEFAULT
SETUP DDC
TEST PATTERN
1
2
4
3
VIDEO SOURCE:
1
2
Selecting this function will enable the user to select the type of input signal to show
4
3
fullscreen. Available inputs are: Analog RGB1, Analog RGB2, DVI, Composite
Video, and S-Video. The display unit will switch signal source instantly, so if no
signal source is present (physically connected) the image will be black for 1-2
seconds before it resets back to the previous detected signal.
POWER OFF:
1
2
Selecting this function will start the shutdown procedure for the unit. Please
3 4
read the STATUS LED overview section for more information.
EXIT:
1
2
Selecting this function will exit the OSD menu and save the current settings.
3 4
Note:
The OSD settings will also automatically be stored in memory when the OSD exit on user timeout .
Operation
IND100064-14
: Load your own custom settings.
: Save your own custom settings.
: Will reset the VGA controller settings to the factory preset.
Use caution when using this function, as this will override
your current settings.
: Display Data Channel. Reset/optimize image information.
This function should be executed to setup correct DDC
(Display Data Channel) information when the backpack has
been replaced. It allows the display to send its specifications
to the display controller.
: Shows a generic test pattern.

INB100026-1 (Rev 9)