Charge Print - Fuji Xerox ApeosPort-IV 5070 User Manual

11 Job Status

Charge Print

This feature authenticates users on the machine to prevent unauthorized users from
operating print jobs. When this feature is enabled, the machine prints only the jobs of
authenticated users. You can also configure the machine to store print jobs temporarily,
and then print them from the machine's control panel.
If received print jobs are set to be saved as Charge Print under [Tools] >
[Authentication/Security Settings] > [Authentication] > [Charge/Private Print Settings] >
[Receive Control], the jobs are saved for each Billing ID. Any jobs that were not given
a Billing ID on the print driver are saved in [No User ID].
For more information on how to register user IDs on the machine, refer to "5 Tools" > "Accounting" >
"Create/View User Accounts" in the Administrator Guide.
Note
For information on how to set Charge Print, refer to "5 Tools" > "Authentication/Security Settings" >
"Authentication" > "Charge/Private Print Settings" in the Administrator Guide.
The following describes how to print and delete a job stored with the Charge Print
feature.
1
Press the <Log In/Out> button on the control panel, or select the login information field
on the touch screen.
2
Enter the user ID, and select [Enter].
Note
11
3
Select [Charge Print].
4
Select the user to check, and select
[Job List].
Note
378
• Unlike the Private Charge Print feature, the Charge Print feature can store jobs without a
user ID, such as e-mail printing and print jobs sent from ContentsBridge or CentreWare
Internet Services, and can print the jobs after authenticating users.
• [Charge Print] appears when [Save as Charge Print Job] is selected by using one of the
following procedures in System Administration mode:
• Selecting [Save as Charge Print Job] in [Receive Control].
• Selecting [According to Print Auditron] in [Receive Control], and then selecting [Save as
Charge Print Job] in [Job Login Failure].
• Selecting [According to Print Auditron] or [Save as Private Charge Print Job] in [Receive
Control], and then selecting [Save as Charge Print Job] in [Job without User ID].
• When a passcode is set, enter the user ID
and select [Next]. Then, enter the
passcode and select [Enter].
• While a user is authenticated, the <Log
In/Out> button is lit on the control panel.
• To exit Authentication mode, press the
<Log In/Out> button on the control panel.
• Select [Refresh] to display the updated
information.
• Select [ ] to return to the previous
screen or [ ] to move to the next screen.
• You can enter a user ID in [Go to] using
the numeric keypad to display the user ID
at the top of the list.