4 - 2
DS4800 Series Corded Digital Imager Product Reference Guide
User Experience
DS4800 Series imagers offer user-friendly features that enhance the decoding experience.
a quick reference for selecting these triggering and decoding features.
User Experience Options
Table 4-1
Trigger Definitions
Tone / Audio Click
Haptic
Good Decode Feedback Definitions
Tone / Beep
Scan Tone Selection
Haptic
Indicator LED
* indicates the default value.
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to set the speaker volume to
low, scan the Low Volume bar code listed under
warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats, require scanning
several bar codes. See these parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
User Preferences/Miscellaneous Options Parameter Defaults
Table 4-2
lists defaults for user preferences parameters. To change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, see
•
Configure the imager using the 123Scan
NOTE See
miscellaneous default parameters.
Feature
Appendix A, Standard Default Parameters
Parameter
Number
1252
On / Off*
1251
On* / Off
56
On* / Off
145
Tones 1* - 5, Low,
Medium, High
613
On / Off*
744
On* / Off
Speaker Volume on page
Default Parameters on page
2
configuration program (see
for all user preferences, hosts, symbologies, and
Table 4-1
Page
Options
Number
4-16
4-16
4-7
4-10
4-13
4-12
4-9. The imager issues a fast
4-5.
123Scan2 on page
10-1).
provides