5 - 6
DS4800 Series Corded Digital Imager Product Reference Guide
Snapshot Mode Timeout
Parameter # 323
This parameter sets the amount of time the digital imager remains in Snapshot Mode. The digital imager exits
Snapshot Mode when you pull the trigger, or when the Snapshot Mode Timeout elapses. To set this timeout
value, scan the bar code below followed by a bar code from
value is 0 which represents 30 seconds; values increment by 30. For example, 1 = 60 seconds, 2 = 90
seconds, etc.
Snapshot Aiming Pattern
Parameter # 300
Select Enable Snapshot Aiming Pattern to project the aiming pattern when in Snapshot Mode, or Disable
Snapshot Aiming Pattern to turn the aiming pattern off.
*
Enable Snapshot Aiming Pattern
(1)
Appendix G, Numeric Bar
Snapshot Mode Timeout
Disable Snapshot Aiming Pattern
(0)
Codes. The default