Host Connection
The DS4800 imager supports USB connection to a host. To connect the imager:
Plug the USB connector at the end of the cable into a USB port on the host.
1.
USB Host Connection
Figure 1-2
The imager defaults to the HID keyboard interface type. To select another USB interface type, scan a
2.
USB Device Type on page
On first installation when using Windows, the software prompts to select or install the Human Interface
3.
Device driver. To install this driver, provided by Windows, click Next through all the choices and click
Finished on the last choice. The imager powers up during this installation.
If problems occur with the system, see
Supported USB Protocols
The imager supports the following protocols over USB:
•
HID Keyboard (default mode) for the following operating systems:
• Windows XP 32/64 bit
• Windows 7 32/64 bit
• Windows 8 32/64 bit
• Apple OS: Mac OS versions 10.6.x, 10.7.x, and 10.8.x (HID keyboard only)
•
SNAPI
•
COM Port Emulation
•
IBM SurePOS (Yellowstone) (IBM Handheld, IBM Tabletop, OPOS)
•
USB-CDC
•
Toshiba TEC
The HID keyboard interface supports the international keyboards listed in
3-4.
Troubleshooting on page
Getting Started
12-3.
Appendix B, Country
1 - 3
Codes.